Sharp GX-M10H(OR), GX-M10H(RD) operation manual Setting the clock Remote control only continued

Setting the clock (Remote control only) (continued)

5To adjust the hour, press the or button

and then press the ENTER button. Press the or button once to advance the time by 1 hour. Hold it down to advance continuously.

6To adjust the minutes, press the or button

and then press the ENTER button. Press the or button once to advance the time by 1 minute. Hold it down to advance the time by 5 minutes interval.

To confirm the time display:

Press the CLOCK/TIMER button. The time display will appear for about 5 seconds.

Notes:

z When power supply is restored after unit is plugged in again or after a power failure, confi rm the clock, if required, reset the clock (pages 6 - 7).

z The clock will continue counting for a few hours should there be a power failure or the AC power lead becomes disconnected.

To readjust the clock:

Perform “Setting the clock” from step 1. If the “CLOCK” does not appear in step 2, step 4 (for selecting the 24-hour or 12-hour display) will be skipped.

To change the 24-hour or 12-hour display:

1Clear all the programmed contents. [Refer to “Factory reset, clearing all memory” on page 21 for details.]

2Perform “Setting the clock” from step 1 onwards.

Listening to the iPod, iPhone or iPad

Notes:

z Charging terminal for iPod, iPhone and iPad:

Condition	DOCK	USB terminal
USB function	YES	YES
		(without iPod or
		iPhone docking)
Other function	YES	NO
(iPod / CD /
Tuner / Audio In)
Stand-by	YES	NO

z Fully charge the iPod, iPhone and iPad with AC power before using GX-M10H battery operation.

z The message “This accessory is not made to work with iPhone” or similar, may appear on the iPhone screen when:

-battery is low.

-the iPhone is not properly docked (eg. slanting). If this occurs, remove and re-dock the iPhone.

zThis product is made for iPod, iPhone and iPad. To prevent random interference when iPod, iPhone or iPad is connected, the headphone output is disabled, and “HPINVALID” will be displayed.

You may also experience brief audio interference during incoming calls.

zThe headphone output is switched off during inserting iPod, iPhone and iPad unit. This is an Apple product specifi cation.

„ iPod, iPhone and iPad connection (USB only)

Made for:

z iPod touch (4th generation) z iPod touch (3rd generation) z iPod touch (2nd generation) z iPod touch (1st generation) z iPod classic

z iPod nano (6th generation) z iPod nano (5th generation) z iPod nano (4th generation) z iPod nano (3rd generation)

z iPod nano (2nd generation) z iPhone 4S

z iPhone 4 z iPhone 3GS z iPhone 3G

ziPhone

ziPad (3rd generation)

ziPad 2

ziPad

1 Insert the connector to the iPod, iPhone or iPad.

iPad

Connector

Caution:

Please update your iPod, iPhone and iPad unit to the latest software version before using it. Please visit Apple’s homepage to download the latest version for your iPod, iPhone and iPad.

2 Place the iPad to the stand for iPad.

iPad

Stand for iPad

3 Connect the iPod, iPhone or iPad to the unit via USB connector.

Note:

USB terminal does not support VIDEO out.

7