Sharp HT-X1W operation manual E-18, Speaker connection, Attaching the optional floor speaker stand

2

!Speaker connection

Make sure to leave the AC power lead disconnected when con- necting the speakers.

To prevent accidental short circuits between and terminals, connect the speaker wires to the speakers first and then to the subwoofer/amplifier unit.

When connecting speakers, match the colours of the back label, tube for the speaker wire, and speaker terminal of the subwoofer/amplifier unit.

1Connect the wires to the speakers. Example: To connect the left front speaker.

Caution:

"The supplied speakers are exclusively for the HT-X1W. Do not connect them to other equipment, and do not connect other speakers to the HT-X1W. It may cause malfunction.

"Do not mistake the and , and right and left terminals of the speaker wires. (The right speaker is placed on the right when you face the subwoofer/amplifier unit.)

"Do not stand or sit on the speakers. You may be injured.

"Do not allow any objects to fall into or to be placed in the bass reflex ducts.

"The speaker grilles are not removable.

" Do not short-circuit the speaker wire. If it happens with the power on, the protection circuit is activated and the system enters the

HT-X1W

ENGLISH

Use

2Connect the other end to the subwoofer/amplifier unit.

Label (white)

Red

Tube (white)

Black

Tube (white)

Black Red

stand-by mode. In this case, check that the

speaker wire is connected correctly before turning on the power again.

Incorrect

!Attaching the optional floor speaker stand

The front speakers and surround speakers support the optional floor speaker stand (see page 64). Remove the original stand for each speaker using a screwdriver first. For details, refer to the manual for the floor speaker stand.

Preparation for

SHARP TINSZA048AWZZ (LA)

	Speaker
Subwoofer/	terminal
	(white)
amplifier unit

Note:

Keep the removed speaker stands or screw in a safe place.

7

E-18

05/2/2 HT-X1W(LA)E2.fm TINSZA048AWZZ