Sharp HTSB250 Placing the sound bar, Installing the sound bar, System preparation continued

System preparation (continued)

2Make a hole on the wall following the screw point marks on the pattern paper by using a drill.

1-1/4” (32 mm)

3/8” (8-9 mm)

Wall surface

Fix a wall mount plug into the hole using a hammer, until it is flush with the wall surface.

1-1/4” (32 mm)

3/8” (8-9 mm)

Wall surface

Screw the wall mount angle to the wall as shown in the illustration. (Total screw is 8 pieces)

Wall mount angle

Wall surface

Wall mount angle

■Installing the sound bar

Align the wall mount slot at the unit to the wall mount angle.

2Slot the unit into the wall mount angle.  Fix them securely.

Wall surface

Placing the sound bar

Installation image:

TV

(screws x 4)(screws x 4)

Wall surface

Wall mount angle

Wall surface

Note:

Make sure all screws are fully tightened. (screws are not supplied)

VCR DVD player

Place the unit as shown.

Notes:

●As the sound from the unit is omni- directional, you can place the unit anywhere you like. However, it is recommended to place it as close to the TV as possible.

●The front panel of the unit is not removable.

Caution:

●Do not change the installation direction when the unit is turned on.

●Do not stand or sit on the unit as you may be injured.

E-