Falling prevention
Safety wires (not supplied) are useful to prevent the unit from falling off the table.
Loop the safety wires (not supplied) into each hole as shown and tie the safety wires to the LCD TV stand.
Sound bar connections to TVs
Caution:
Turn off all other equipment before making any connections.
Tuner receiving for other audio system
● Placing the antenna near the unit AC power cord may cause noise pick up. Place the antenna away from the unit for better reception.
Notes:
● To connect to TV, use either LINE IN 1 jacks or AUDIO LINE IN 2 jack only.
● Refer the operation manual of the equipment to be connected.
● Fully insert the plugs to avoid fuzzy pictures or noises.
■Connecting to a TV
If the TV/monitor has an audio output, connect it to the LINE IN 1 jacks on the rear of the unit.
■Connecting to a TV (with Headphone jack)
If the TV/monitor has headphone jack, connect it to the LINE IN 2 jack on the rear of the unit.
HEADPHONE
TV | To audio output |
| |
RCA cable (supplied) | jacks |
| |
| To LINE IN |
| 1 jacks |
Sound bar
To select LINE IN 1 function:
●On the unit: Press FUNCTION button repeatedly until “L1” is displayed.
●On remote control: Press LINE button repeatedly until “L1” is displayed.
E-
TV | To HEADPHONE |
| jack |
Audio cable | To AUDIO |
(not supplied) | |
| LINE IN 2 |
| jack |
Sound bar
To select LINE IN 2 function:
●On the unit: Press FUNCTION button repeatedly until “L2” is displayed.
●On remote control: Press LINE button repeatedly until “L2” is displayed.
Notes:
●If the TV volume is continuously in low level, the unit will automatically power off. Increase the TV output volume to enjoy the sound from the unit.
●If the unit volume is continuously in very high level, the unit will mute and recover after 3 seconds.
