Sharp LC-32LE511E operation manual Remote Control Handset, Switching the TV On/Off

Remote Control Handset

•Remove the battery cover located on the back of the remote control by gently pulling backwards from the indicated part.

•Insert two AAA/R3 or equivalent type batteries inside. Observe the correct polarity (+/-) when inserting batteries and replace the battery cover.

Note: Remove the battery from remote control when it is not to be used for a long period. Otherwise it can be damaged due to any leakage of batteries.

Switching the TV On/Off

To Switch the TV On

Connect the power cord to the 220-240V AC 50 Hz.

•Switch the “” button on the rear left hand side to position “” so the TV will switch to standby mode. Then the standby LED lights up.

•To switch on the TV from standby mode either:

•Press the “” button, P+ / P- or a numeric button on the remote control.

•Press the “” or +/- button on the TV.

•The TV will then switch on.

Note: If you switch on your TV via PROGRAMME UP/DOWN buttons on the remote control or on the TV set, the programme that you were watching last will be reselected.

By either method the TV will switch on.

To Switch the TV to Standby

To switch the TV to low power standby press the

“” button on the remote control or right hand side of the TV.

Note: When the TV is switched to standby mode, standby LED can blink to indicate that features such as Standby Search, Over Air Download or Timer is active.

To Switch the TV Off

•Switch the “” button bottom right edge under the

screen to position 2 as illustrated, to isolate the TV from the mains, the LED will go out.

•If the TV will not be used for a long period i.e. holidays, then unplug the power cord from the mains socket.

Digital Teletext (** for UK only)

•Press the “” button.

•The digital teletext information appears.

•Operate it with the coloured buttons, cursor buttons and OK button.

The operation method may differ depending on the contents of the digital teletext.

Follow the instructions displayed on digital teletext screen.

•When Press “SELECT” button or similar message appears on the screen, press the OK button.

•When the “” button is pressed, the TV returns to television broadcasting.

•With digital terrestrial broadcasting (DVB-T), in addition to digital teletext broadcasting together with the normal broadcasting, there are also channels with just digital teletext broadcasting.

•The aspect ratio (picture shape) when watching a channel with just digital teletext broadcasting is the same as the aspect ratio of the picture viewed previously.

•When you press the “” button again, the digital teletext screen will be displayed.

English - 16 -