Sharp LC-37X20S, LC-32X20S, LC-37X20E Preparation, Supplied accessories, Attaching the stand unit

Preparation

Supplied accessories

Remote control unit	AC cord	Cable clamp (g1)	Stand unit (g1)
(g1)
	(For Europe, except (For U.K. and Eire)
	U.K. and Eire)

U.K. type 3-pin AC cord is only included with

models LC-32X20E and LC-37X20E.

Pages 3 and 6	Page 8	Page 8	Page 5
• Operation manual (This publication)		• “AAA” size battery (g2) ... Page 6

Attaching the stand unit

•Before attaching (or detaching) the stand, unplug the AC cord from the AC INPUT terminal.

•Before performing work spread cushioning over the base area to lay the TV on. This will prevent it from being damaged.

CAUTION

•Attach the stand in the correct direction.

•Be sure to follow the instructions. Incorrect installation of the stand may result in the TV falling over.

1Confirm that there are 10 screws with the stand unit.

2Attach the supporting post for the stand unit onto the base using the 6 screws with the screw driver (supplied) as shown.

31Insert the stand into the openings on the bottom of the TV. (Hold the stand so it will not drop from the edge of the base area.)

2Insert and tighten the 4 screws into the

4 holes on the rear of the TV.

2

Soft cushion

1

NOTE

•To detach the stand unit, perform the steps in reverse order.

5