65

Wireless installation

Use the wireless LAN USB adapter supplied with the
TV.
EWireless connection overview

nPC

oWireless LAN router/access point

pWireless LAN USB adapter (supplied)

qNetwork

NOTE
• When using the SHARP wireless LAN USB adapter
(supplied), try to provide as much free space around the
device for best performance.
• Make sure the firewalls in your network allows access to
the TV wireless connection.
• Operations cannot be guaranteed when used with
access points that do not have Wi-Fi® certification.
• A wireless LAN access point is required to connect
the TV to the Internet using a wireless LAN. See the
operation manual of your access point for setup.
EHow to connect

1Switch on your router before starting the

network installation.

2Connect the wireless LAN USB adapter

(supplied) to the USB 3 (WIRELESS LAN) port on
the rear of the TV.
• Do not use a wireless LAN adapter other than
the supplied SHARP wireless LAN adapter, as
operations cannot be guaranteed.

3Go to “Network setup” > “Auto setup”, and then

press ;.
NOTE
• Follow the on-screen instructions when setting
manually.
Go to “Network setup” > “Manual setup”.

4Press a/b to select “Wireless”, and then press

;.

5Confirm the WPS location and then press ; to

go to the next step.

6Perform “Connection test” after the connection

is completed. Press c/d to select “Yes”, and
then press ;.

7The connection test result will be displayed on

the screen. Follow the on-screen instructions for
the settings after this step.
NOTE
• When not using “Push button”, perform the settings
from “Network setup” > “Manual setup” > “Connection
type”.
• To connect your TV to the internet, you must have a
broadband internet connection.
• If you do not have a broadband internet connection,
consult the store where you purchased your TV or ask
your internet service provider or telephone company.
• There is no need to enter the security key for
subsequent connections to the wireless network.
• If your access point is set to a stealth mode (that
prevents detection by other devices), you may not be
able to establish a connection. In this case, disable the
stealth mode on the access point.
• If you want to change the IP settings manually, go to
“Network setup” > “Manual setup” > “IP” setup” and
follow the on-screen instructions and the operation
manual of the router.
• See page 85 to check the supplied SHARP wireless LAN
adapter specifications.

Network setup