Sharp LC70LE655U Preparation, Installing Batteries in the Remote Control Unit, Antennas

QUICK REFERENCE Preparation

Installing Batteries in the Remote Control Unit

If the remote control fails to operate TV functions, replace the batteries in the remote control unit.

1Open the battery cover.

Using the Remote Control Unit

Use the remote control unit by pointing it towards the remote control sensor on the TV. Objects between the remote control unit and the remote control sensor may prevent proper operation.

Antennas

To enjoy a clearer picture, use an outdoor antenna. The following is a brief explanation of the types of connections that are used for a coaxial cable. If your outdoor antenna uses a 75-ohm coaxial cable with an F-type connector, plug it into the antenna terminal at the rear of the TV set. For connecting the antenna cable to the TV, use commercially available cables.

Connecting Antenna Cable

•Connect the antenna cable to the TV using one of the methods in the illustration as shown (1, 2, 3 or 4).

2Insert two "AAA" size batteries (supplied with the product).

•Place the batteries with their terminals corresponding to the (e) and (f) indications in the battery compartment.

3Close the battery cover.

Remote control sensor

30°

17´ (5 m)

30°

30°

30° *

* The angle is 6º when the stand is attached.

■Cautions regarding the remote control unit

• Do not expose the remote control unit to shock. In addition, do not expose the remote control unit to liquids, and do not place it in an area with high humidity.

• Do not install or place the remote control unit under direct sunlight. The heat may cause deformation of the remote control unit.

• The remote control unit may not work properly if the remote control sensor on the TV is under direct sunlight or strong lighting. In such cases, change the angle of the lighting or the TV, or operate the remote control unit closer to the remote control sensor.

1 Cable without a CATV converter

2 VHF/UHF antenna

3 Combination VHF/ UHF antenna

4 Separate VHF/UHF antenna

	Home Antenna
Cable TV lead-In	terminal (75-ohm)
	Coaxial cable

Home Antenna 75-ohm coaxial cable (round) terminal (75-ohm)

Coaxial cable

75-ohm coaxial cable (round)

	300-ohm twin-lead			o	r		300/75-ohm
	cable (flat)						adapter
	UHF
	ANTENNA
VHF			300-ohm
ANTENNA			twin-lead cable
						IN		OUT	To TV antenna
	300-ohm twin-lead cable					Combiner
									terminal
	or	75-ohm coaxial cable

CAUTION

Improper use of batteries can result in chemical leakage or explosion. Be sure to follow the instructions below.

•Do not mix batteries of different types. Different types of batteries have different characteristics.

•Do not mix old and new batteries. Mixing old and new batteries can shorten the life of new batteries or cause chemical leakage in old batteries.

•Remove batteries as soon as they are worn out. Chemicals that leak from batteries that come in contact with skin can cause a rash. If you fi nd any chemical leakage, wipe thoroughly with a cloth.

•The batteries supplied with this product may have a shorter life expectancy due to storage conditions.

•If you will not be using the remote control unit for an extended period of time, remove batteries from it.

IMPORTANT:

IF THE UNIT DOES NOT POWER ON - UNPLUG THE TELEVISION FROM THE OUTLET AND REPEAT THE INSTALLATION STEPS.

IF YOU STILL ENCOUNTER NO POWER, PLEASE CONTACT US AT 1-800-BE-SHARP.

1. A 75-ohm system is generally a round cable with F-type connector	F-type connector
that can easily be attached to a terminal without tools.	75-ohm coaxial cable (round)
2. A 300-ohm system is a fl at "twin-lead" cable that can be attached
to a 75-ohm terminal through a 300/75-ohm adapter.
NOTICE F-type connector should be finger-tightened only.	300-ohm twin-lead cable (fl at)
When connecting the RF cable to the TV set, do not tighten	F-type connector
F-type connector with tools.
If tools are used, it may cause damage to your TV set. (The
breaking of internal circuit, etc.)	75-ohm coaxial cable

10