Instructions for attaching a VESA compliant arm
An arm or stand based on the VESA standard (commercially available) can be attached to the monitor.
Procurement of the arm or stand is at the custom- er's discretion.
When choosing the arm to be installed please take note of the following points.
-The arm should be compatible with the VESA standard, and there must be a gap of 100mm x 100mm between the screw holes on the section to be attached.
-The arm must not fall off or break off after being attached to the monitor.
1.Ensure that both the monitor and computer are switched off.
2.Unplug the power cord from the AC outlet.
3.Remove the analog signal and audio cables from the computer.
4.Fold back the display section.
1)If carrying out adjustments to the monitor, place it upright.
2)While pressing the rear lock disable button, gently fold back the monitor.
Lock disable button
-Do not overly bend the cable or add extension cords as this could lead to malfunction.
5.Being careful not to damage the monitor, spread out a soft cloth and lay the monitor on it display- side down.
6. Attach the arm to the monitor with four screws.
Note:
-The screws used to attach the arm should be M4 screws with a length of 7 mm ~ 10 mm protruding from the surface to be attached. Using different screws could lead to malfunction or may lead to the monitor falling off,internal damaged,personal injury.
7 - 10mm
Screw used to attach arm
Arm
Part of monitor to which arm is attached
7.Connect the analog signal and audio cables and power cord.
English
25
