Sharp MD-MX30 MD operation manual Compact Disc Operation, CD playback

COMPACT DISC OPERATION

■CD playback

1	3,5
	6
	2
	Label side up
	4
3" (8 cm)	5" (12 cm)
	6
	2
1

1 Press the ON/STAND-BY button to turn the power on.

2 Press the CD ■ button.

3 Press the 7 button to open the disc tray.

4 Place the CD on the disc tray, label side up.

●Be sure to place 3" (8 cm) CD in the middle of the disc tray.

5 Press the 7 button to close the disc tray.

●The total number of tracks and the total playing time will be displayed.

Total number of tracks Total playing time

6 Press the CD 06 button to start playback from track 1.

●When the last track has been played back, the unit will stop automatically.

To interrupt playback:

Press the CD 06 button.

●“ 6 ” will appear.

●Press the CD 06 button again to resume playback from the same point.

To stop playback:

Press the CD ■ button.

To remove the CD.

Press the 7 button.

After use:

Press the ON/STAND-BY button to enter the stand-by mode.

Caution:

●Do not carry the unit with a CD left in the disc tray. The disc may come loose inside the unit and it may be dam- aged or cause damage to the unit.This may also cause malfunctions.

●Do not push the disc tray while it is moving.

●If the power fails while the tray is open, wait until the power is restored.

●If the disc tray is stopped forcibly, "E-CD20" will appear in the display and the unit will not function.

If this occurs, press the ON/STAND-BY button to enter the stand-by mode and then turn the power on again.

●Subjecting the unit to shock or vibration may cause mistracking.

●Playing certain CDs at a high volume may cause mistracking. In this case, listen at a lower volume.

●If TV or radio interference occurs during CD operation, move the unit away from the TV or radio.

13