Sharp MD-MX30 MD operation manual Preset tuning, Preset memory scan, Clear Memory Enter

(Continued)

■Preset tuning

You can store up to 40 stations in memory (40 stations con- sisting of any combination of AM and FM stations you like) and recall them.

2,4 3

3

2,4

To enter stations into memory:

1 Perform steps 1 - 5 in the "Tuning" section.

2 Press the MEMORY/ENTER button.

MEMORY

3 Within 5 seconds, turn the jog dial or press the PRE- SET (Xor W) button to make the preset channel num- ber flash in the display.

●Store the stations in memory, in order, starting with preset channel 1.

When is displayed, a station has already been stored in this preset number memory.

4 Within 5 seconds, press the MEMORY/ENTER button to store that station in the selected station preset num- ber memory.

MEMORY

●If the "MEMORY" and preset number indicators go out before the station is memorized, repeat the operation from step 2.

5 Repeat steps 1 - 4 to set other stations, or to change a preset station.

●When a new station is stored in the selected station pre- set number memory location, the previously memorized station in that location will be erased.

To recall a memorized station:

Turn the jog dial or press the PRESET (X or W) button for less than 0.5 seconds to select the desired station.

●The stations (preset channel number, frequency and fre- quency band) which have been stored in memory will ap- pear in the display in numerical order, irrespective of the frequency bands.

Backup function:

The backup function protects all station presets for a few hours should there be a power failure or the AC power cord is re- moved from the AC outlet.

■Preset memory scan

The stations saved in the preset memory can be scanned automatically.

	PRESET
CLEAR	(X W)
MEMORY/
ENTER

1 To scan the preset stations, press the PRESET (X or W) button for more than 0.5 seconds.

●The station preset number will flash and the programmed stations will be tuned in sequentially, for 5 seconds each.

2 Press the PRESET (X or W) button again to stop the memory scan at the desired station.

Note:

When the preset memory does not have any stations stored in it, the preset memory scan will not function.

To erase the memorized station:

1 Recall the memorized station to be erased by turning the jog dial or pressing the PRESET (X or W) button.

2 Press the CLEAR button.

●"MEMORY" and preset number will flash.

3 Within 5 seconds, press the MEMORY/ENTER button.

4 Repeat steps 1-3 to erase other memorized stations.

To erase all memorized stations:

When the unit is in the stand-by mode, hold down the TUNER (BAND) and the MD ■ buttons, and then press the ON/ STAND-BY button.

●"PRESET CLR" will appear.

20