Sharp PG-D4010X Setting up the Projector Using RS-232C or Telnet, When Connecting Using RS-232C

Setting up the Projector Using RS-232C or Telnet

Connect the projector to a computer using RS-232C or Telnet, and open the SETUP MENU on the computer to carry out various settings for the projector.

When Connecting Using RS-232C

1 Launch general purpose terminal emulator.

2 Input settings for the RS-232C port of the terminal emulator as follows.

Baud Rate	: 9600 bps*
Data Length	: 8 bit
Parity Bit	: None
Stop Bit	: 1 bit

Flow Control : None

*This is the factory default setting. If the value of Baud Rate for the projector has been changed, set Baud Rate here according to the changed value on the projector.

7 Input “setup” and press the “Enter” key.

• SETUP MENU will be displayed.

▼SETUP MENU

-----------------------------	SETUP MENU----------------------------
[1]IP Address	[2]Subnet Mask	[3]Default Gateway
[4]User Name	[5]Password
[6]RS-232C Baud Rate	[7]Projector Name	[8]DHCP Client
[A]Advanced Setup		[D]Disconnect All
[V]View All Setting	[S]Save & Quit	[Q]Quit Unchanged
setup>

Note

•User name and password are not set in the factory default settings.

•If the user name or password is entered incorrectly three times, SETUP MENU will be quit.

3

4

5

Input “PJS11234” and press the “Enter” key.

“OK” is displayed. Input “PJS25678” and press the “Enter” key within 10 seconds.

“User Name:” is displayed. Input the user name and press the “Enter” key.

•If a user name has not yet been set, just press the “Enter” key.

6 “Password:” is displayed. Input the password and press the “Enter” key.

•If a password has not yet been set, just press the “Enter” key.

-20