Sharp PG-D4010X Setting up the Projector Using RS-232C or Telnet, 1IP Address, 3Default Gateway

Setting up the Projector Using RS-232C or Telnet

The setting procedure for each item will be explained. For the basic procedure, please refer to “Set Items” on page 23.

IP Address Setting

([1]IP Address)

Setting of IP address.

setup>1			1
IP Address		:192.168.150.2	2
Please Enter		:192.168.150.3
(change)	—>	192.168.150.3		*

1 Enter “1” and press the “Enter” key.

2 Enter numerical value to be set and press the “Enter” key.

Display IP address after change (*).

Default Gateway Setting

([3]Default Gateway)

Setting default gateway.

setup>3		1
note: “0.0.0.0” means “Using no default gateway.”
Gateway Address :0.0.0.0		2
Please Enter	:192.168.150.1
(change)	—> 192.168.150.1		*

1 Enter “3” and press the “Enter” key.

2 Enter numerical value to be set and press the “Enter” key.

Display gateway address after change (*).

Subnet Mask Setting

([2]Subnet Mask)

Setting subnet mask.

setup>2		1
Subnet Mask	:255.255.255.0	2
Please Enter	:255.0.0.0
(change) —>	255.0.0.0		*

1 Enter “2” and press the “Enter” key.

2 Enter numerical value to be set and press the “Enter” key.

Display subnet mask after change (*).

Note

•If the values for IP Address, Subnet Mask or Gateway of the projector have been changed via Telnet, the computer cannot be connected to the projector depending on the computer's network settings.

User Name Setting

([4]User Name)

Carrying out security protection using user name.

setup>4		1
User Name	:	2
Please Enter	: XX-XXXX
(change)	—> XX-XXXX
		*

1 Enter “4” and press the “Enter” key.

2 Enter user name and press the “Enter” key. Display set user name (*).

Note

•User name can be up to 8 characters.

•You can input the characters below: a-z, A-Z, 0-9, -, _

•In the default state, user name is not set.

-25