4. Adjust the projected image with the Setup Guide
1After the projector turns on, the Setup Guide appears. (When “Setup Guide” is set to “On”. See page 45.)
2Follow the steps in the Setup Guide and adjust the focus, height (angle) and picture size.
3After adjusting the focus, height (angle) and picture size, press ENTER to finish the Setup Guide.
|
|
|
| _P. 24 | |
5. Correct trapezoidal distortion |
|
| |||
Correcting trapezoidal distortion using Keystone Correction. |
|
| |||
|
| Shrinks |
| Shrinks | |
On the remote control | upper side. | lower side. | |||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
_P. 26
6. Select the Input mode
Press INPUT P/R to display the INPUT list. Use INPUT P/R to select the Input mode.
On the | On the remote | INPUT list |
| |
projector | control |
|
| |
INPUT | Audio | |||
|
| |||
|
|
|
|
COMPUTER
H HDMI
VVIDEO
When you select HDMI input, use O/Q to select the audio input terminal (HDMI or AUDIO).
_P. 27
7.Turn the computer on
8.Turn the power off
Press STANDBY/ON on the projector or STANDBY on the remote control, and then press the button again while the confirmation message is displayed to put the projector into Standby mode.
On the | On the remote |
projector | control |
_P. 23
Easy Start
15
