Sharp PG-LW2000 appendix Using 3D Viewing Mode, Projecting 3D images, Ending 3D projection

Viewing Stereoscopic 3D Images (Continued)

		Press 3D MODE on the remote
	6
Using 3D Viewing Mode		control to display the 3D MODE
		menu.

Use the following procedure to project 3D images.

For operation of the 3D LCD shutter glasses and the 3D-video playback equipment, see the corresponding operation manual.

ENTER button

O/Q buttons

Info

•If “An invalid button has been pressed.” is displayed, a 3D-compatible signal is not being input. Check the output signal on the playback equipment.

7 Press Q to set “DLP® Link™” to “On”.

8 Press ENTER to switch the mode and enable more natural 3D image viewing.

3D MODE button

Projecting 3D images

1 Turn the projector on.

2 Turn the 3D-video playback equipment on.

•Set the 3D-video playback equipment so that it outputs one of the signals listed in the Compatibility Chart in this operation

manual.

3 Switch the Input mode of the projector to enable input of 3D video signals.

4 Operate the 3D-video playback equipment and play back the 3D content.

5Turn the 3D LCD shutter glasses

on and place them over your eyes.

Warning!

•If the projector, 3D-video playback equipment, and 3D LCD shutter glasses are not properly set, you may experience eye strain in addition to not being able to view the images in 3D.

9 Press 3D MODE.

• The 3D MODE menu will disappear.

Note

•If the images are not displayed in 3D, repeat steps 6 to 8.

•You can also use “DLP® Link™” and “DLP® Link™ Invert” on the menu screen to change the 3D setting.

Ending 3D projection

1 Press 3D MODE on the remote control to display the 3D MODE menu.

2 Press O to set “DLP® Link™” to “Off”.

3 Press 3D MODE.

• The 3D MODE menu will disappear.

52