Troubleshooting (Continued)
Problem | Check | Page |
|
|
|
3D images flicker when | • Images may appear to flicker when fluorescent light or ambient light | – |
watching in a room. | enters your vision. |
|
|
| |
|
| |
Ghosting (a double image) | • Check that you are using 3D LCD shutter glasses that support the | – |
occurs without the image | DLP® Link™ system. |
|
appearing in 3D. |
| |
| system. |
|
| • Check that the shutters on the 3D LCD shutter glasses are working | – |
| properly. |
|
|
| |
|
| |
|
| |
| Some 3D LCD shutter glasses are equipped with a special viewing |
|
| mode (such as “dual view mode”) in addition to the normal 3D |
|
| viewing mode. See the operation manual of your 3D LCD shutter |
|
| glasses. |
|
|
|
|
| • Check the settings of the projector. | – |
|
| |
|
| |
|
|
|
| • Check whether a signal that is not supported is being input. | 67 |
|
| |
| rate. |
|
| Make sure you are running your 3D application in resolutions that |
|
| support 3D. To support 3D, your 3D application must be configured |
|
| to run at the correct settings for this projector. |
|
| For details on the supported signals, see “3D Supported Signals” of |
|
| the Compatibility Chart. |
|
| • If the projector is connected to a computer for 3D image playback, | – |
| check that a |
|
|
| |
|
| |
| • Check that there are no obstructions between the screen and the 3D | – |
| LCD shutter glasses. |
|
|
| |
| Any obstructions may cause the glasses not to function properly |
|
| causing the lenses to flicker or turn off. Do not place your hand or |
|
| other objects in front of the 3D control signal sensor on the glasses. |
|
| • Check whether there is a source of high intensity lighting nearby. | – |
|
| |
| High intensity lighting can interfere with communication between the |
|
| 3D LCD shutter glasses and the screen resulting in some flicker. |
|
| • Check whether two or more projectors are projecting 3D images at the | – |
| same time. |
|
|
|
This unit is equipped with a microprocessor. Its performance could be adversely affected by incorrect operation or interference. If this should happen, unplug the Unit and plug it in again after more than 5 minutes.
70