TURNTABLE MOTOR AND FOOD LAMP SOCKETS REMOVAL
1.Disconnect the power supply cord.
2.Open the door and block it open.
3.To discharge the high voltage capacitor, wait for 60 seconds.
4.Remove the one (1) screw holding the base cover to the oven cavity back plate.
5.Remove the three (3) screws holding the base cover to the oven cavity front face plate.
6.Open the base cover.
7.Release the two hood lamp sockets from the base cover.
8.Remove the base cover from the oven cavity by pulling down and moving to the left slightly.
TURNTABLE MOTOR
9.Disconnect the wire leads from the turntable motor. 10.Remove one (1) screw holding turntable motor to the
oven cavity.
11.Now the turntable motor is free.
HOOD LAMP SOCKET
9.Screw the hood lamp off from the lamp socket. 10.Disconnect the wire leads from the lamp socket by
pushing the terminal hole of the lamp socket with the small flat type screw driver.
11.Now, the lamp socket is free.
OVEN LAMP AND LAMP SOCKET REMOVAL
1.Disconnect the power supply cord.
2.Open the door and block it open.
3.Remove three (3) screws holding the hood exhaust louver to oven cavity front face plate.
4.Remove the hood exhaust louver from the oven by pushing the right and left tabs of the hood exhaust louver. (Refer to procedure of "HOOD EXHAUST LOUVER REMOVAL")
5.Remove one (1) screw holding the control panel to the oven cavity front face plate.
6.Release the control panel from the oven cavity front face plate by lifting it up and tilting top edge back.
7.Turn the lamp socket and release it from the magnetron duct.
8.Screw the oven lamp off from the lamp socket.
9.Now, the oven lamp is free.
10.Pull the wire leads from the oven lamp socket by pushing the terminal hole of the oven lamp socket with the small flat type screw driver.
11.Now, the oven lamp socket is free.
Oven lamp socket 
Terminal
Wire lead
Terminal hole
Flat type small screw driver
POSITIVE LOCK® CONNECTOR (NO-CASE TYPE) REMOVAL
1.Disconnect the power supply cord and remove the oven from wall and remove outer case. (Refer to procedure of "Removal of Oven from Wall" and "Outer case Removal")
2.Open the door and block it open.
3.To discharge the high voltage capacitor, wait for 60 seconds.
4.Push the lever of positive lock® connector.
5.Pull down on the positive lock® connector.
CAUTION: WHEN CONNECTING THE POSITIVE LOCK® CONNECTORS TO THE TERMINALS, IN- STALL THE POSITIVE LOCK® SO THAT THE LEVER FACES YOU.
Terminal
Positive lock® connector
1
Push
Lever
2
Pull down
Positive lock® connector
CONTROL PANEL ASSEMBLY, CONTROL UNIT AND KEY UNIT REMOVAL
1.Disconnect the power supply cord.
2.Open the door and block it open.
3.To discharge the high voltage capacitor, wait for 60 seconds.
4.Remove three (3) screws holding the hood exhaust louver to oven cavity front face plate.
5.Remove the hood exhaust louver from the oven by pushing the right and left tabs of the hood exhaust louver. (Refer to procedure of "HOOD EXHAUST LOUVER REMOVAL")
6.Remove one (1) screw holding the control panel to the oven cavity front face plate.
7.Release the control panel from the oven cavity front face plate by lifting it up.
8.Disconnect the wire leads from the relays RY1 and RY2.
9.Disconnect the connectors
10.Remove the control panel assembly from the oven. 11.Now, the control panel assembly is free. 12.Disconnect the connector
29
