1 | 2 | 3 |
|
|
5
14 | 10 | 9 | 8 | 6 | 4 | 7 |
11
12
13
Hub (inside)
15. Turntable (glass)
17.Coupling 
16. Turntable support
18. Rack
OVEN AND ACCESSORIES
OVEN
1.Door
2.Door hinges
3.Oven lamp
4.Waveguide cover (DO NOT REMOVE)
5.Control panel
6.Coupling
7.Door latches
8.Oven cavity
9.Door seals and sealing surfaces
10.Door safety latches
11.Ventilation openings
12.Outer cabinet
13.Power supply cord
14.Door handle
ACCESSORIES:
Check to make sure the following accessories are provided:
(15) Turntable (16) Turntable support (17) Coupling (18) Rack
•Place the turntable support in the centre of the oven floor so that it can freely rotate around the coupling. Then place the turntable on to the turntable support so that it locates firmly into the coupling.
•To avoid turntable damage, ensure dishes and containers are lifted clear of the turntable rim when removing them from the oven.
For use of the rack, refer to the grilling sections on page
Never touch the grill when it is hot.
NOTE: When you order accessories, please mention
two items: part name and model name to your dealer or SHARP authorised service agent.
INSTALLATION INSTRUCTIONS
1.Remove all packing materials from the oven cavity, (do not remove the waveguide cover), and the feature sticker from the outside of the door, if there is one. Check the unit for any damage, such as a misaligned door, damaged door seals around the door or dents inside the oven cavity or on the door. If there is any damage, please do not operate the oven until it has been checked by a SERVICE CENTRE APPROVED BY SHARP and repaired, if necessary.
2.Accessories provided
1) Turntable 2) Roller stay
3) Operation manual and Cooking guide
3.Ensure that the coupling is installed.Place the turntable support on the oven floor, then place the turntable onto the turntable support and coupling, ensuring it is located firmly. Refer to the diagram above.NEVER operate the oven without the turtable.
4.This oven is designed for countertop or cabinet use as well. It should not be installed in any area where excessive heat and steam are generated, for example, next to a conventional oven unit. The oven should be installed so as not to block ventilation openings. Allow a space of at least 30 cm on the top, 5 cm on both sides and at the rear of the oven for adequate air circulation. When installing in a cabinet, the minimum inside dimension of the cabinet should be 542 mm (W) x 557 mm (H) x 408 mm (D). This oven is not designed for
WARNING: The electrical outlet must be readily accessible so that the unit can be unplugged easily in an emergency.
5.Neither the manufacturer nor the distributors can accept any liability for damage to the machine or personal injury for failure to observe the correct electrical connecting procedure.
The A.C. voltage must be single phase 230 – 240V, 50Hz.
6.This appliance must be earthed.
7.Operate the oven from a general purpose domestic outlet.
If a generator is used, do not operate the oven with
3
