Sharp VL-A110U Using the Hand Strap and the Lens Cap, Attaching the Shoulder Strap, Lens side

Preparation

Preparation

Using the Hand Strap and the Lens Cap

1 Open the hand strap flap (Q) and grip

strap (W), and pass the grip strap through the loop at the end of the lens cap cord (E).

Hand strap flap

Grip strap

Notes:

•Always replace the

lens cap on the lens when the VIEWCAM is not in use.

• Attach the lens cap to the hand strap so it will not get in the way during recording.

Attaching the Shoulder Strap

1 Hold one end of the strap and thread it through the loop on the left side of the LCD screen.

2 Pass your hand through the hand strap and put your thumb close to the Power Zoom control. Then pull the grip strap tight until it fits snugly, seal the Velcro® closures (Q), and close the hand strap flap (W).

Caution:

•Do not swing the VIEWCAM by the hand strap.

Attaching and Removing the Lens Cap

When attaching or removing the lens cap, press both tabs on the sides of the cap.

Press both tabs.

2 Loosen the strap in the buckle, then feed the end of the strap through the buckle, as shown.

3 Draw the strap in the direction of the arrow to secure.

4–6Use the same procedure to attach the other end of the strap to the loop on the lens side.

LCD screen side	Lens side
1	4

2	5
Buckle	Buckle

3 6

17