OPERATOR MAINTENANCE
1In case of Power Failure
When power is lost, the machine retains its memory contents and all information on sales entries.
•When power failure is encountered in register idle state or during an entry, the machine returns to normal operation after power recovery.
•When power failure is encountered during a printing cycle, the register prints “========” and then carries out the correct printing procedure after power recovery. (See the sample print.)
2In Case of Printer Error
If the printer runs out of paper, the printer will stall, and “PPPPPPPPPP” will appear on the display. Key entries will not be accepted. Refer to section 5 in this chapter, install a new roll, then press the lkey. The printer will print the power failure symbol and resume printing.
If the print head comes up, the printer stalls, “H” will appear on the extreme left of the display. Key entries will not be accepted. Bring the print head back to the correct position, then press the lkey. The printer will print the power failure symbol and resume printing.
3Cautions in Handling the Printer and Recording Paper
Cautions in handling the printer
• Avoid dusty and humid environments, direct sunlight and iron powder (a permanent magnet and electromagnet are used in this machine.)
• Use the print head release lever only when necessary.
• Never pull the paper when it is in contact with the print head. First release the head with the print head release lever, and then remove the paper.
• Never touch the surface of the print head.
• Never touch around the print head and the motor during printing or before they have had sufficient time to cool.
Cautions in handling the recording paper (thermal paper)
•Use only the paper specified by SHARP.
•Do not unpack the thermal paper until you are ready to use it.
•Avoid heat. The paper will color at around 70°C.
•Avoid dusty and humid storage places. Avoid direct sunlight.
•The printed text on the paper can discolor under conditions of high humidity and temperature, exposure to the direct sunlight, contact with glue, thinner or a freshly copied blueprint, and heat caused by friction from scratching or other such means.
•Be very careful when handling the thermal paper. If you want to keep a permanent record, copy the printed text with a photocopier.
62
