Sharp XL-UH1H Enhancing your system, Troubleshooting chart, E-13, Headphones, General, CD player

Enhancing your system

The connection cord is not included. Purchase a commercially available cord as shown below.

Portable audio	Audio cable
player, etc.
	(not supplied)

■Listening to the playback sounds of portable audio player, etc.

1Use a connection lead to connect the portable audio player etc. to the AUDIO IN socket.

2Press the ON/STAND-BY button to turn the power on.

3Press the AUDIO IN button on the remote control or FUNCTION button repeatedly on main unit to select AUDIO IN function.

4Play the connected equipment. If volume level of the connected device is too high, sound distortion may occur. Should this happen, lower the volume of the connected device. If volume level is too low, increase the volume of the connected device.

Note:

To prevent noise interference, place the unit away from the television.

■Headphones

●Do not turn the volume on to full at switch on and listen to music at moderate levels. Excessive sound pressure from earphones and headphones can cause hearing loss.

●Before plugging in or unplugging the headphones, reduce the volume.

●Be sure your headphones have a 3.5 mm (1/8”) diameter plug and impedance between 16 and 50 ohms. The recommended impedance is 32 ohms.

●Plugging in the headphones disconnects the speakers automatically. Adjust the volume using the VOLUME control.

Troubleshooting chart

Many potential problems can be resolved by the owner without calling a service technician. If something is wrong with this product, check the following before calling your authorized SHARP dealer or service center.

■General

Symptom				Possible cause
● The clock is not			● Did a power failure occur?
set to the correct			Reset the clock. (Refer page
time.			11)
● When a button is			● Set the unit to the power
pressed, the		unit	stand-by mode and then turn
does not respond.			it back on.
			● If the unit still malfunctions,
			reset it. (Refer page 14)
● No	sound	is	● Is the volume level set to
heard.			“MIN”?
			● Are	the	headphones
			connected?
			● Are	the	speaker wires
			disconnected?

■CD player

	Symptom				Possible cause
● Playback			does		● Is the disc loaded	upside
not start.					down?
● Playback			stops		● Does the disc satisfy the
in	the	middle		or	standards?
is	not	performed			● Is the disc distorted or
properly.					scratched?
● Playback			sounds		● Is the unit located near
are skipped,				or	excessive vibrations?
stopped			in	the	● Is the disc very dirty?
middle of a track.					● Has condensation	formed
					inside the unit?

■Remote control

Symptom	Possible cause
● The remote control	● Is the AC power lead of the
does not operate.	unit plugged in?
	● Is the	battery	polarity
	correct?
	● Is the battery dead?
	● Is the distance or angle
	incorrect?
	● Does the	remote	control
	sensor receive strong light?

■ Tuner

Symptom		Possible cause
● The radio	makes	● Is the unit placed near the TV
unusual	noises	or computer?
continuously.		● Is the FM aerial placed
		properly?
		Move the aerial away from
		the AC power lead if it is
		located nearby.

E-13