Remote control - battery installation
Note:
Before using remote control, please remove plastic shield at battery holder.
1Whilst pushing the locking tab towards the center of the remote control, slide out the battery holder.
Back of remote
Plasticcontrol
Remote shield control
Battery holder | Locking tab |
2Remove the old battery from the battery holder, insert the new battery and then slide the battery holder back into the remote control.
Battery holder | Positive (+) |
| side up |
Polarity
(+) symbol
Battery type
Locking tab
Precautions for battery use:
Remove the battery if the unit will not be used for long periods of time. This will prevent potential damage due to battery leakage.
Caution:
●Do not use rechargeable battery
●Danger of explosion if battery is incorrectly replaced.
●Replace only with the same or equivalent type.
●Batteries (battery pack or battery installed) shall not be exposed to excessive heat such as sunshine, fire or the like.
●Installing the battery incorrectly may cause the unit to malfunction.
Notes concerning use:
●Replace the battery if the operating distance is reduced or if the operation becomes erratic. Purchase “CR 2025”, coin lithium battery.
●Periodically clean the transmitter on the remote control and the sensor on the unit with a soft cloth.
●Exposing the sensor on the unit to strong light may interfere with operation. Change the lighting or the direction of the unit if this occurs.
●Keep the remote control away from moisture, heat, shock, and vibrations.
General control
■To turn the power on
Function | Main unit | Remote | Operation | |
control | ||||
|
|
| ||
Power on/ |
|
| Press to turn the | |
off |
|
| power on or to | |
|
|
| go to | |
|
|
| mode. | |
|
|
|
|
■Volume auto set-in
●If you turn off and on the main unit with volume set to 16 or higher, the volume will start at 16.
●If you turn the unit off then on again with the volume level set to less than 16, it will turn on again at the level set.
■Volume control
Press the VOLUME +/– button to increase or decrease the volume.
■Extra bass control (X-BASS)
When the
■Auto power off function
The main unit will enter the
CD/USB: In the stop or pause mode.
TUNER: No reception of broadcast signal.
AUDIO IN: No detection of input signal.
■Muting
The volume is muted temporarily when pressing the MUTE button on the remote control. Press again to restore the volume.