Sherwood RD-6106 manual Operations, Before operation, Listening To A Program Source, English

Operations

LISTENING TO A PROGRAM SOURCE

Before operation

Enter the standby mode.

MAIN POWER

ON/ OFF

The STANDBY indicator lights up.

This means that the receiver is not disconnected from the AC mains and a small amount of current is retained to support the memorized contents and operation readiness.

To switch the power completely off, push the POWER switch again.

The power is cut off and the STANDBY indicator goes off.

In the standby mode, turn the power on.

1

POWER

STANDBY

ON/STANDBY

or

Each time the STANDBY button on the front panel or the POWER button on the remote control is pressed, the receivers turns on to enter the operating mode or off to enter the standby mode.

In the standby mode, if the INPUT SELECTOR button is pressed, the receiver turns on automatically and the desired input is selected.

Switch the speakers on.

2	SPEAKER
	ON/OFF

The SPEAKER indicator lights up and sound can be heard from the speakers connected to the speaker terminals.

When using headphones for private listening, press the SPEAKER button again to switch the speakers off.

Select the desired input source.

3

	INPUT SELECTOR
AUDIO	VIDEO	TAPE MON.	CD	TUNER VIDEO1
			AUX	TAPE MON. VIDEO2
			or	VIDEO3

Each time the “AUDIO” button is pressed, the input source changes as follows;

TUNER CD AUX (frequency display)

Each time the “VIDEO” button is pressed, the input source changes as follows;

VIDeo 1 VIDeo 2 VIDeo 3

When the TAPE MONITOR button is set to on so that “TAPE M” indicator lights up, other inputs can not be heard from the speakers.

To listen to an input source other than TAPE MONITOR, be sure to set the TAPE MONITOR button to off.

TAPE MONITOR function

You can connect either a tape deck or a graphic equalizer to the receiver’s TAPE MONITOR jacks.

To listen to the component connected to these jacks, set the TAPE MONITOR button to on.

If you connect a 3-head tape deck, you can monitor the actual recording, not the source sound.

For further details, refer to the operating instructions of the component connected.

When selecting the 6 CH DIRECT as desired,

6CH DIRECT

or

6CH DIRECT

6-DIRECT is displayed and the 6 separate analog signals from a decoder or DVD player connected to this unit will be heard. You can use the tone controls and volume control to adjust the signal. (If the TAPE MONITOR button is set to on, it will be automatically set to off.)

To cancel the 6 DIRECT function, press the 6 CH DIRECT button again or select another desired input source.

These 6 separate analog signals can be heard, only. They cannot be recorded.

ENGLISH

11