Adjusting each channel level | 8 | Adjust the level of the selected channel | ||
as desired. | ||||
Select the desired channel. |
| |||
|
|
| ||
7 |
|
|
| |
|
|
| ADJUST | |
CHANNEL |
|
| or | |
SELECTOR |
|
| ||
or | CH SEL. |
| CH LEVEL | |
Each time this button is pressed, the corresponding | If the channel display disappears, start from the | ||||||||
channel is selected and displayed for 3 seconds as | above step 7 again. | ||||||||
follows; |
|
|
|
|
|
|
| ||
| Front Left | Center | Front Right |
|
|
|
|
| |
|
| ||||||||
|
|
|
|
|
| ||||
| SubWoofer | Rear Left | Rear Right |
|
| 9 | Repeat the above steps 7 and 8 to | ||
|
| ||||||||
When it is in the normal stereo or Dolby Virtual | |||||||||
adjust the other channel levels. | |||||||||
mode, or the speaker setting is “N”, center, rear or | |||||||||
| |||||||||
|
| ||||||||
subwoofer channel will not be selected. |
|
| |||||||
In Dolby Digital or Dolby Pro Logic | 11 | Repeat steps 7 to 9 in “Adjusting each |
channel level” until the sound level of each | ||
| speaker is heard to be equally loud. | |
|
In these modes, the volume level of each channel can be adjusted easily with the test tone function.
Enter the test tone mode.
10
Cancel the test tone function.
12
T.TONE
T.TONE
The test tone will be heard from the speaker of each channel for 2 seconds as follows;
Front Left | Center | Front Right |
|
|
|
| |||
SUBwoofer | Rear Left | Rear Right |
| |
| ||||
Speakers set to “N” are not available and will not be heard.
ENGLISH
17
