| Select the desired preset number (1~30) and | 4 | Repeat the above steps 1 to 3 to memorize | |||
3 | other stations. | |||||
press the MEMORY/ENTER button. | ||||||
| ||||||
TUNING/PRESET |
| MEMO/ENTER |
| |||
|
|
|
|
|
|
• When using the NUMERIC buttons on the remote |
| ||||
| |||||
control. | 3 |
|
| MEMORY BACKUP FUNCTION | |
Examples) For “3” : |
|
|
| ||
For “15” : | 1 within 2 seconds 5 | The following items, set before the receiver is turned | |||
|
|
| off, are memorized. | ||
|
|
|
| ||
For “30” : | 0 |
|
| • INPUT SELECTOR settings | |
|
|
| • Surround mode settings | ||
|
|
|
| ||
• The station has now been stored in the memory. | • Preset stations,etc. | ||||
Note : If the electricity fails or the AC input cord is | |||||
• When using the NUMERIC buttons, the station is | |||||
stored automatically without pressing the | disconnected for more than 2 weeks, they are all | ||||
MEMORY/ENTER button. | cleared. So you should memorize them again. |
•A stored frequency is erased from the memory by storing another frequency in its place.
•If “MEM” goes off, start again from the above step 2.
|
|
|
| Select the desired | TUNING/PRESET | ||
Tuning to preset stations |
| 2 |
|
| |||
| preset number. |
|
|
| |||
|
|
|
|
|
| ||
1 | After selecting the tuner as an input |
|
|
|
| ||
|
|
|
|
| |||
source, select the preset tuning mode. | • When using the NUMERIC buttons on the remote | ||||||
| T/P MODE |
| control. |
| 3 |
|
|
|
|
| Examples) For “3”: |
|
|
| |
|
|
|
| For “15”: | 1 | within 2 seconds 5 |
|
|
|
|
|
|
|
| |
|
|
|
| For “30”: | 0 | 3 within 2 seconds | 0 |
|
|
|
|
| (or | ) | |
• Then “PRESET” lights up. |
| • When selecting the desired preset number with the | |||||
|
|
| NUMERIC buttons, the desired preset station will be | ||||
|
|
| tuned to automatically without selecting the preset | ||||
|
|
| tuning mode. |
|
|
| |
Listening to FM stereo broadcasts |
| Scanning preset stations in sequence | |||||
• While listening to FM broadcasts. | FM MODE |
|
|
|
|
| |
• Each time this button is pressed, |
|
|
|
| P.SCAN |
| |
|
|
|
|
|
| ||
the FM mode changes as follows; |
|
|
|
|
|
| |
Stereo mode : “ST” lights up. |
|
|
|
|
|
| |
Mono mode : “ST” goes off. |
|
|
|
|
|
| |
• When FM stereo broadcasts are poor because of weak | • The receiver will start scanning the stations in the preset | ||||||
broadcast signals, select the FM mono mode to reduce | sequence and each station is received for 5 seconds. | ||||||
the noise, then FM broadcasts are reproduced in | • At the desired station, press this button again to stop | ||||||
monaural sound. |
| scanning. |
|
|
|
|
ENGLISH
21