Sherwood RD-6500 manual Operations, Listening to a Program Source

Operations

LISTENING TO A PROGRAM SOURCE

ENGLISH

Before operation
• Enter the standby mode.	MAIN POWER
	ON/ OFF

•The STANDBY indicator lights up.

This means that the receiver is not disconnected from the AC mains and a small amount of current is retained to support the memorized contents and operation readiness.

•To switch the power off, push the POWER switch again.

•Then the power is cut off and the STANDBY indicator goes off.

In the standby mode, turn the power on.

1	POWER
	STANDBY

ON/STANDBY

or

•Each time the STANDBY button on the front panel or the POWER button on the remote control is pressed, the receiver is turned on to enter the operating mode or off to enter the standby mode.

•In the standby mode, if the INPUT SELECTOR button is pressed, the receiver is turned on automatically and the desired input is selected.

Switch the speakers on.

2	SPEAKER
	ON/OFF

•Then the SPEAKER indicator lights up and the sound can be heard from the speakers connected to the speaker terminals.

•When using the headphone for private listening, press the SPEAKER button again to switch the speakers off.

Select the desired input source.

3		VIDEO1
		VIDEO2
	INPUT SELECTOR
AUDIO	VIDEO	TAPE MON.

	VIDEO3
	CD
or	TUNER
	AUX
	T.MON

•Each time the “AUDIO” button is pressed, the input source changes as follows;

TUNER CD AUX (frequency display)

•Each time the “VIDEO” button is pressed, the input source changes as follows;

VIDEO 1 VIDEO 2 VIDEO 3

•When the TAPE MONITOR button is set to on so that “TAPE M” indicator lights up, other inputs can not be heard from the speakers.

To listen to an input source other than TAPE MONITOR, be sure to set the TAPE MONITOR button to off.

TAPE MONITOR function

You can connect either a tape deck or a graphic equalizer to the receiver’s TAPE MONITOR jacks.

Only when you listen to the component connected to these jacks, set the TAPE MONITOR button to on.

If you connect a 3-head tape deck, you can listen to the sound being recorded during recording, not the source sound.

For further details, refer to the operating instructions of the component connected.

When selecting the 6 CH DIRECT as desired,

6CH DIRECT

•“6-DIRECT” is displayed and the 6 separate analog signals from 6 CH decoder connected to this unit pass through the tone (bass, treble) and volume circuits only and directly transfer to the speakers. (In case that the TAPE MONITOR button is set to on, the TAPE MONITOR button is automatically set to off.)

•Press the 6 CH DIRECT button or select the desired input source to cancel the 6 CH direct function.

•These 6 separate analog signals can be heard only, not recorded.

10