Sherwood RVD-9090R Before operation, Listening To A Program Source, TAPE MONITOR function

LISTENING TO A PROGRAM SOURCE

Before operation

Enter the standby mode.	ON/OFF
	POWER

The STANDBY indicator lights up. The receiver remains connected to

the AC main electrical supply and a small amount of current is retained to support the on-board memory and rapid turn-on.

To switch the power off, push the POWER switch again.

Then the power is cut off and the STANDBY indicator goes off.

In the standby mode, turn the power on.

1

POWER

STANDBY

or

Each time the STANDBY button on the front panel or the POWER button on the remote control is pressed, the receiver turns on and enters the operating mode or turns off to enter the standby mode.

In the standby mode, pressing any INPUT SELECTOR button automatically turns the receiver on and selects the desired input.

Switch the speakers on.

2

SPEAKER

The SPEAKER indicator will light up and sound can be heard from the speakers connected to the receiver’s speaker terminals.

When using the headphone for private listening, press the SPEAKER button again to turn the speakers off.

Select the desired input source.

3

INPUT SELECTOR
AUDIO
TAPE	CD	TUNER
MONITOR
VIDEO	AUX	TAPE MON.

or

DVD/TV

VCR1 VCR2

Each time the “AUDIO” button is pressed, the input source changes as follows;

TUNER CD AUX (frequency display)

Each time the “VIDEO” button is pressed, the input source changes as follows;

VCR1 VCR2 DVD

When the TAPE MONITOR button is set to on, the “TAPE M” indicator lights up and the source connected to the TAPE MONITOR input can be heard. To listen to a source other than the one connected to the TAPE MONITOR, be sure the TAPE MONITOR is set to off.

TAPE MONITOR function

Either a tape deck or a graphic equalizer can be connected to the receiver’s TAPE MONITOR jacks. To listen to the component connected to these jacks, press the TAPE MONITOR button to on.

If a 3-Head tape deck is connected to the TAPE MONITOR jacks, you can listen to the sound directly from the tape while it is being recorded and not the source.

For further details, refer to the operating instructions of the component connected to these jacks.

When the VCR 2 is selected as input source. Select the front or the rear VCR 2.

VCR 2 SEL.

If the front VCR 2 is selected, the “VCR 2 SEL” button lights up.

ENGLISH

15