Adjusting each channel level | 7 | Adjust the level of the selected | ||||
channel as desired. |
| |||||
6 | Select the channel to adjust. |
| ||||
|
|
| ||||
|
|
|
|
|
| |
|
|
|
|
| CHANNEL LEVEL |
|
| CH SELECTOR |
|
| or | CHANNEL LEVEL | |
|
| or | CHANNEL |
|
| |
|
|
|
|
| ||
|
| SEL. |
|
|
| |
Each time this button is pressed, the corresponding | If the channel display disappears, you must start | |||||
again from step 6, above. |
| |||||
channel is selected and displayed for 3 seconds in the |
| |||||
|
|
| ||||
following order; |
|
|
|
|
| |
Front Left | Center | Front Right |
|
|
| |
SubWoofer | Rear Left | Rear Right | 8 | Repeat the above steps 6 and 7 to | ||
If the receiver is in the STEREO mode, the center, | adjust the levels of the other channels. | |||||
|
| |||||
rear and subwoofer channels are not available and |
|
| ||||
will not be displayed. |
|
|
|
| ||
Speakers set to “N” are not available and will not be |
|
|
| |||
displayed. |
|
|
|
|
| |
In Dolby Digital |
| Perform the adjustments in steps 6 to 8 in | ||||
Logic Mode |
|
|
| “Adjusting each channel level” until the | ||
|
| 10 sound from each speaker is perceived to be | ||||
|
|
|
| |||
In these modes, the volume level of each channel |
| equally loud. |
| |||
can be adjusted using the test tone function. |
|
|
| |||
9 | Engage the Test Tone mode by pressing |
|
|
| ||
the Test Tone button on the remote |
|
|
| |||
control. |
|
|
|
|
| |
|
|
|
|
| Cancel the test tone function by pressing | |
|
| T.TONE |
| 11 the Test Tone button on the remote control. | ||
The test tone will cycle from channel to channel and |
|
|
| |||
will be heard from each speaker for 2 seconds as |
|
|
| |||
follows; |
|
|
|
| T.TONE |
|
|
|
|
|
|
| |
Front Left | Center | Front Right |
|
|
| |
SUBwoofer | Rear Left | Rear Right |
|
|
|
Speakers set to “N” are not available and will not be displayed.
ENGLISH
13