Sherwood RVD-9090R Using the OSD, Current Status Display, Menu Screen, English

Models: RVD-9090R

1 29
Download 29 pages 30.66 Kb
Page 24
Image 24
Using the OSD

ENGLISH

Using the OSD

This unit incorporates an OSD(On screen display) function to provide information about basic operation of this unit and to simplify the set-up procedures.

The OSD function uses a monitor TV connected to this unit as a display and has two kinds of display modes; current status display and menu screen.

Note:

Any on screen display visible on the monitor TV will not be recorded on VCR 1.

CURRENT STATUS DISPLAY

This mode shows the status corresponding to each operation.

The on screen display will automatically disappear in 5 seconds.

For examples, there are 2 status displays as follows.

When selecting the desired input source.

CD (ANALOG)

Input source Signal input

When selecting the TEST TONE mode.

(( CURRENT STATUS DISPLAY ))

FL C FR

SW

RLRR

FL

 

 

 

------------------- 0

 

 

 

 

Channel level or overall volume display

When adjusting each channel level or overall volume, the volume level display will be shown.

The test tone display will be shown until the test tone mode is canceled.

MENU SCREEN

This function simplifies the set-up procedure such as speaker mode, function select, surround mode, delay

time and channel level trim.

 

 

 

The menu screen operation is performed easily with the CURSOR control(

), ON SCREEN

DISPLAY and (MEMORY/) ENTER buttons.

 

 

The FM MODE button on the front panel corresponds to the CURSOR UP(

) button on the remote control,

the CINEMA EQ to the CURSOR DOWN(

), the DYNAMIC RANGE to the CURSOR LEFT( ) and the

SPEAKER MODE to the CURSOR RIGHT(

).

 

 

Turn the menu screen on.

 

 

 

1

 

 

MAIN MENU

 

 

 

 

 

SPEAKER MODE

OSD

 

FUNCTION SELECT

ON SCREEN

 

SURROUND MODE

 

 

DELAY TIME

 

 

CH LEVEL TRIM

or

 

SYSTEM INFORMATION

 

up/down : MOVE

 

 

 

 

OSD : END

ENTER : SELECT

 

 

 

Main menu display

The main menu will be shown.

 

In the bottom of the display, “up” stands for the CURSOR

 

UP( ) button, “down” for the CURSOR DOWN( )

To turn the menu screen off, press this button

“ ” for the CURSOR RIGHT( ) “ ” for the

again.

 

CURSOR LEFT( ) “OSD” for the ON SCREEN

 

 

DISPLAY and “ENTER” for (MEMORY/) ENTER.

24

Page 24
Image 24
Sherwood RVD-9090R operating instructions Using the OSD, Current Status Display, Menu Screen, English