Adjusting the tone (bass and treble)
8. Enter the tone mode.
�Each time this button is pressed, the corresponding tone mode is selected and shown for 3 seconds as follows:
� BASS � TRBL
�Note:
�When the tone direct function is activated, the tone mode cannot be entered and “TON DIR” flickers for 2 seconds.
9. At the desired tone mode, adjust the tone as desired.
�If the tone display disappears, start from the step 8 again.
�Notes:
�Extreme settings at high volume may damage your speakers.
�In general, the bass and treble levels are adjusted to 0.
10. To listen to a program source without the tone effect.
�“TON DIR” is displayed, “DIRECT” lights up and the sound that bypasses the tone circuitry will be heard.
�To cancel the tone direct function, press this button again to display “TON CTRL”, and then "DIRECT" goes off.
Adjusting the sound volume balance
11. Enter the balance mode.
�“BAL” and the balance level is displayed for 3 seconds.
12. Adjust the sound volume balance between the left and right speakers.
�If the balance display disappears, start from the step 11 again.
�Note:
�In general, the balance level is adjusted to 0.
12
