Tuning to preset stations
1. After selecting the tuner as an input source, select the preset mode.
• Then “PRESET” lights up.
2. Select the desired preset number.
Listening to FM stereo broadcasts
Scanning preset stations in sequence
•When using the NUMERIC buttons on the remote control.
Examples) For “3” : 
For “15” :
For “30” :
•When selecting the desired preset number with the NUMERIC buttons, the desired preset station will be tuned to automatically without selecting the preset mode.
•While listening to FM broadcasts, press the FM MODE button.
•Each time this button is pressed, the FM mode changes as follows:
�Stereo mode : “ST” lights up.
Mono mode : “ST” goes off. �
•When FM stereo broadcasts are poor because of weak broadcast signals, select the FM mono mode to reduce the noise, then FM broadcasts are reproduced in monaural sound.
•The receiver will start scanning the stations in the preset sequence.
•At the desired station, press this button again to stop scanning.
15
