Shindaiwa 81359 manual Mixing Fuel, Filling the Fuel Tank, Starting the Engine

Mixing Fuel

CAUTION!

Some types of gasoline contain alcohol as an oxygenate. Oxygenated gaso- line may cause increased operating temperatures. Under certain condi- tions, alcohol-based gasoline may also reduce the lubricating qualities of some 2-cycle mixing oils. Never use any type of gasoline containing more than 10% alcohol by volume! Generic oils and some outboard oils may not be intend- ed for use in high-performance 2-cycle engines, and should never be used in your Shindaiwa engine.

CAUTION!

This engine is designed to operate on a 50:1 mixture consisting of unleaded gasoline and ISO-L-EGD or JASO FC class 2-cycle mixing oil only. Use of non-approved mixing oils can lead to excessive carbon deposits.

nUse only fresh, clean unleaded gasoline with a pump octane of 87 or higher.

nMix all fuel with a 2-cycle air-cooled mixing oil that meets or exceeds ISO-L-EGD and/or JASO FC classified oils at 50:1 gasoline/oil ratio.

Examples of 50:1 mixing quantities

n1 gallon of gasoline to 2.6 oz. mixing oil

n5 liters of gasoline to 100 ml. mixing oil

IMPORTANT!

Mix only enough fuel for your immediate needs! If fuel must be stored longer than

30 days and oil with fuel stabilizer is not used, it should first be treated with a fuel stabilizer such as STA-BIL™.

Oil is a registered JASO FC classified oil and also meets or exceeds ISO-L-EGD performance requirements. Shindaiwa One is recommended for use in all Shindaiwa low emissions engines and

Filling the Fuel Tank

WARNING!	n NEVER start or operate this unit if
Minimize the risk of fire!		the carburetor, fuel lines, fuel tank
		and/or fuel tank cap are damaged.
n STOP engine before refueling.
	n	NEVER smoke or light any fires
n ALWAYS allow the engine to cool
		near the engine or fuel source!
before refueling!	n	NEVER place any flammable mate-
n Wipe all spilled fuel and move the
		rial near the engine muffler!
engine at least 10 feet (3 meters)	n	NEVER operate the engine without
from the fueling point and source
		the muffler and spark arrester in

before restarting!	good working condition.
n NEVER start or operate this unit if
there is a fuel leak.

also includes a fuel stabilizer.

1.Place the trimmer on a flat, level surface.

2.Clear any dirt or other debris from around the fuel filler cap.

3.Remove the fuel cap, and fill the tank with clean, fresh fuel.

4.Reinstall the fuel filler cap and tighten firmly.

Starting the Engine

IMPORTANT!

Engine ignition is controlled by a two position switch mounted on the throttle housing labeled, "I" for ON or START and "O" for OFF or STOP.

Hand Grip

Figure 14 C242

1.Slide the ignition switch to the “ON” position. See Figure 14.

Return Tube

Primer Bulb

Figure 15

2.Press the primer bulb until fuel can be seen flowing in the transparent return tube.

IMPORTANT!

The primer system only pushes fuel through the carburetor. Repeatedly pressing the primer bulb will not flood the engine with fuel.

3.Set the choke lever to the CLOSED position if engine is cold.

Closed

Figure 16

Make sure the

cutting

attachment

is clear of obstructions!

Figure 17

4.While holding the outer tube firmly with left hand. Use your other hand to slowly pull the recoil starter handle until resis- tance is felt, then pull quickly to start the engine.

CAUTION!

Do not pull the recoil starter to the end of the rope travel. Pulling the recoil starter to the end of the rope travel can damage the starter.

10