Shindaiwa 81359 manual Assembly, Cutting Attachment Shield, Sub-Shield C242

Assembly

Cutting Attachment Shield

Socket-	Bracket
Head Cap	Outer
Screw
	Tube

Shim

Clamp Screw

	Shim
Retaining	Cutting	Cutting
Nut	Attachment Mounting
		Attachment
	Plate
		Shield

Figure 5

Cutting Attachment Shield

Line Cutter

	Sub-shield with
Figure 5A	Line Cutter

Install the Cutting Attachment Shield C242

1.Insert the cutting attachment shield between the outer tube and the cutting attachment mounting plate. See Figure 5.

NOTE:

It may be necessary to loosen the retaining nut and clamp screw to adjust cutting attach- ment shield mounting plate.

WARNING!

NEVER operate the unit without the cutting attachment shield installed and tightly secured!

Sub-Shield C242

(when trimmer head is in use)

Cutting Attachment Shield

Hook

Receiver

2.	Fit the two shims and the bracket over
	the outer tube and loosely install the
	four socket-head screws. See Figure 5.
3.	Tighten the four socket-head cap screws
	to secure the cutting attachment shield.

1.Attach the shield extension to the cutting attachment shield. See figure 6.

WARNING!

Sub-shield

Figure 6

Hook

4. Re-tighten clamp screw and retaining nut.

CAUTION!

Make sure the clamp screw and retaining nut are securely tightened before tightening the four socket-head cap screws.

NEVER use this machine without sub-shield when using a trimmer head.

CAUTION!

Make sure the sub-shield is completely hooked at the hook receiver.