Installing a Trimmer Head
NOTE:
The C242 is shipped with Holder A, Holder B, shaft bolt, and bolt guard installed. The shaft bolt is a
1. With the gear case output shaft facing |
Shaft Bolt (not used)
Bolt Guard
Gear Case
Shaft
up, rotate the gearshaft and holder A |
until the hole in holder A aligns with the |
matching hole in the gear case flange, |
and then lock the holder to the gear by |
inserting the long end of the hex wrench |
through both holes. See Figure 11A. |
2. Using the combination spark plug/ |
screwdriver wrench, remove the shaft |
bolt and bolt guard. See Figure 11A. |
NOTE:
(not used)
Holder B
Holder A
Figure 11A
Hex Wrench
Figure 11B
Make sure holder B is installed on the gear- case with the splined hole engaging the gear- case shaft.
3.Using the hex wrench to secure Holder A , install and
See Figure 11B.
5.Remove the hex wrench from the gear case and holder.