Assembly
Cutting Attachment Shield
Socket- | Bracket | |
| ||
Head Cap | Outer | |
Screw | ||
Tube | ||
|
Shim
Clamp Screw
| Shim |
| |
Retaining | Cutting | Cutting | |
Nut | Attachment Mounting | ||
Attachment | |||
| Plate | ||
| Shield | ||
|
|
Figure 5
Cutting Attachment Shield
Line Cutter
| |
Figure 5A | Line Cutter |
|
Install the Cutting Attachment Shield C242
1.Insert the cutting attachment shield between the outer tube and the cutting attachment mounting plate. See Figure 5.
NOTE:
It may be necessary to loosen the retaining nut and clamp screw to adjust cutting attach- ment shield mounting plate.
WARNING!
NEVER operate the unit without the cutting attachment shield installed and tightly secured!
Sub-Shield C242
(when trimmer head is in use)
Cutting Attachment Shield
Hook
Receiver
2. | Fit the two shims and the bracket over |
| the outer tube and loosely install the |
| four |
3. | Tighten the four |
| to secure the cutting attachment shield. |
1.Attach the shield extension to the cutting attachment shield. See figure 6.
WARNING!
Figure 6
Hook
4. |
CAUTION!
Make sure the clamp screw and retaining nut are securely tightened before tightening the four
NEVER use this machine without
CAUTION!
Make sure the