Shindaiwa PB2500, 80732 manual Assembly Adjust Throttle Lever Free Play, Assembly Handle, English

Assembly: Adjust Throttle Lever Free Play

ENGLISH

The throttle lever free play should be approxiamtely 3/16-1/4 inch(4-6 mm). See Figure 10. Make sure that the throttle lever operates smoothly without binding. If it becomes necessary to adjust the lever freeplay, follow the procedures and illustrations that follow.

PB2500.09

3/16-1/4 inch (4-6 mm)

Throttle Freeplay

Figure 10

PB2500.05

Figure 11

1.Loosen the air cleaner cover knob and remove the air cleaner cover. See Figure 11.

2.Loosen the lock nut on the cable adjuster. See Figure 12.

3.Turn the cable adjuster in or out as required to obtain proper free play 3/16-1/4 inch(4-6 mm).

See Figure 12.

4.Tighten the locknut.

	Lock
Cable	Nut
Adjuster
Figure 12	PB2500.10

5. Reinstall the air cleaner cover.

Assembly: Handle

Connect the Handle to the Outer Tube

1.Remove both screws from the handle.

2.While spreading the handle at the mounting hole, position the handle on the outer tube as shown.

3.Reinstall the two mounting screws in the handle, but do not tighten them at this time.

IMPORTANT!

One side of the handle is recessed to receive the hex nuts.

4.Locate the handle at the best position for operator comfort (usually about 10 inches ahead of the throttle lever), and secure it by tightening the knob at the handle base.

Handle

Mounting

Screw

Adjustment

Knob

Throttle

Assembly

Washer

Hex Nut

PB10

Figure 13

Outer Tube

8