Shindaiwa PB2500, 80732 manual Unit Description, Specifications, Prior to Assembly, English

ENGLISH

Unit Description

Using the accompanying illustrations as a guide, familiarize yourself with this unit and its various components. Understand- ing the product helps ensure top perform- ance, long service life, and safer opera- tion. See Figure 4.

WARNING!

Do not make unauthorized modifica- tions or alterations to this unit or components.

Prior to Assembly

Before assembling, make sure you have all the components required for a com- plete unit:

■Engine assembly

■Outer tube assembly

■Drum kit w/gearcase

■Correct operators handle (see preced- ing page)

■Kit containing operator’s handle and hardware, this manual and tool kit for routine maintenance. Tool kits vary by model and may include a hex wrench, spanner and a combination spark plug wrench/screwdriver.

Carefully inspect all components for damage.

IMPORTANT!

The terms “left”, “left-hand”, and “LH”; “right”, “right-hand”, and “RH”; “front” and “rear” refer to directions as viewed by the operator during normal operation.

			Spark
			Plug
	Handle	Grip
		Ignition
		Switch
Sweeper	Outer Tube
Belt
			Fuel
		Tank
Gearcase		Protector	Tank
		Throttle
		Trigger
	PB03
	Sweeper
	Drum
Figure 4

Specifications

PB2500 Dry Weight (less sweepers)	............................................................	4.7 kg/10.4 lb.
PB2500 Dry Weight (Including sweepers)		9.5 kg/21.0 lb.
Engine Model		Shindaiwa SF2500E
Engine Type		Shindaiwa C4, vertical-cylinder, air-cooled
Bore x Stroke		34 x 27 mm/1.3 x 1.1 in.
Displacement		24.5 cc/1.5 cu. in.
Maximum Power Output		1.1 HP (0.8 kW) @ 7500 rpm (min-1)
Fuel/Oil Ratio	50:1 with Shindaiwa Premium 2-cycle mixing oil
Fuel Tank Capacity		600 ml/20.3 oz.
Carburetor Type		Walbro WYL, diaphragm-type
Ignition		One-piece electronic, transistor-controlled
Spark Plug		NGK CMR6H
Air Cleaner Type		Non-reversible flocked filter element
Starting Method		Recoil
Stopping Method		Slide switch
Transmission Type		Automatic, centrifugal clutch w/worm gear
EPA Emission Compliance Period*		Category A

*The EPA emission compliance period referred to on the emission compliance label located on the engine, indicates the number of operating hours for which the engine has been shown to meet Federal emission requirements. Category C = 50 hours (Moderate), B = 125 hours (Intermediate) and A = 300 hours (Extended)

*Specifications are subject to change without notice.

6