Shopsmith TS-III ULTRA owner manual Add table tab to remaining floating table

3Add table tab to remaining floating table

Mark drill centers on the right edge of the remaining floating table as shown in Fig. 5, then use the (2) #10 x 5/8” self drilling Phillips head fasteners to attach the table tab. See Fig. 6. Leave each of the two fasteners slightly loose to allow the tab to pivot down and

out of the way for other floating table applications. For the model 510 floating table, add self adhesive UHMW to both ends of the tubular rails. Adhere the pads just inside the tubes at the top as shown in Fig. 7.

Figure 7

Figure 5

Figure 6

1 ¾”
9	”
	16
/
4		”
	6
	/1
13

#10 x 5/8” self-drilling fasteners

table tab

For Model 510 floating

table, adhere UHMW pads as shown to front

and rear rails

4Final Shopsmith workstation set up

Loosen the headstock and carriage locks and slide both to the far left end of the way tubes. Tighten the headstock and carriage locks. Now insert (2) 5ʼ extension tubes into the worktable rails allowing 32” of the tubes to extend beyond the right edge of the worktable. Tighten the locking thumbscrews.

Slide the floating table with table tab onto the right end of extension tubes. Slide floating table with drilled access holes onto the right end of the extension tubes. Position this floating table 23” from the worktable and tighten the locking thumbscrews. Now attach the telescoping legs as shown in Fig. 8 and extend to hold the work surface at 90° to the blade.

Figure 8

Leave fasteners loose enough to allow tab to pivot

32”

23”

INCRA TS-III ULTRA Shopsmith Owner’s Manual 5