Shopsmith TS-III ULTRA owner manual Fence Assembly, Loosely attach rip fence

FENCE ASSEMBLY

1Slidebase carriage into Ultra

Slide the carriage into the Ultraʼs base and position the fence mounting bracket above the right edge of the worktable. Pull the carriage clamp up to lock the carriage in place. See Fig. 13.

2Loosely attach rip fence

Open hardware pack B-08.Place a ¼” flat washer on each of (2) ¼-20 x ½” socket head cap screws and insert the screws through the slotted holes on the fence mounting bracket. Thread the ¼-20 square nuts onto the screws, then slide the fence onto the square nuts as shown in Fig. 14, capturing the nuts in the upper T-slot. Allow the infeed end of the fence to overhang the worktable by about 3”. See Fig. 15. Do not tighten the fence mounting screws at this time.

Figure 13	Fence mounting bracket
	Align fence mounting bracket above
	edge of worktable and lock
	carriage clamp

carriage

Figure 14 rip fence

capture nut in upper T-slot

¼-20 x ½” socket head fastener with washer

Figure 15

INCRA TS-III ULTRA Shopsmith Owner’s Manual 7