Settings of the base unit, Signaling method | Siemens 200 specs

Gigaset 200, GBR, A31008-G200-B101-1-7619

BASISST.FM

28.09.01

Settings of the base unit

Normally, no changes are necessary to settings in the base unit.

Settings in the base unit can be easily changed by using the mobile part if necessary.

Prerequisite:

The handset must be registered with the base unit.

Signaling method

You use this function to change to the pulse signaling method.

Factory default: Multifrequency signaling method.

	Press the off-hook key.
	The following appears on the
	display "" .

DIAL MODE

3PULSE

or

TONE

Open the menu.

Confirm.

Select and confirm your desired signaling method

select and confirm. Press the on-hook key.

8If you hold down the 4key, you automati- cally have multifrequency signaling for the subsequent call.

Flash times („R key“)

This function allows you to change the set flash time (factory default see page 20).

3TBR

3180 MS

Press the off-hook key.

Open the menu.

Select and confirm.

Select and confirm the desired flash time (80, 100, 120, 180, 250, 300 or 600 ms).

Press the on-hook key.

18

Image 18

Siemens 200 manual Settings of the base unit, Signaling method, Flash times „R key, Prerequisite

Contents

Be inspired User guide Display symbols and special characters Brief overview of the handset Congratulations Safety information Use only the plug-in power supply unit Contents Connect up the base unit For the analog landline network Put the handset into operation Inserting the batteriesUse only approved, rechargeable batter Place the handset on Base unit Charge the batteries Recommended batteries Operating times/charging times Accepting a call Making a phone callCalling Redialing Displaying the callers number Clip Activating/deactivating the key lock Storing a new entry Using the phone book to dialPhone book Changing an entry Registering the handset with the base unit Step Confirm your entry Receiver volume Settings of the handsetVolumes and tunes Ringing tone volume Resetting the handset to the factory defaults Changing the display language Factory defaults of the handset Function Flash times „R key Settings of the base unitSignaling method Prerequisite Pulse/no-pulse ratio Resetting the base unit to the factory defaults Factory defaults of the base unit Function Appendix TroubleshootingProblem Possible Solution Cause Caring for your phone Guarantee RangeSiemens Limited, ICM Fitzwilliam Court, Leeson Close Dublin Kingdom ServiceUnited Ireland Settings of the handset Menu overviewExamples Settings of the base unit Index New entry phone book 12 Number, see call number