B)Changing the tips on the upper large double flame burner.
The glass panel and the frame are fixed to the rest of the cooking hob by means of clips. The following steps must be taken to remove both the glass panel and frames:
1 - Remove all the burners, caps, diffusers, etc. Fig. 5a.
2 - Loosen the two screws on the rapid, semi- rapid and auxiliary burners. Fig. 5b.
3 - Loosen the three screws on the large double flame burner. Fig. 5c.
Fig. 5
5a
5b
5c
IMPORTANT INFORMATION
4 - Use the disassembly lever 483196 available from our technical assistance service. To release the front clips, apply the lever in the area shown in figures X1, X2, depending on the hob model.
Never use the lever on glass edges which have no trim or frame!
Before putting the glass back, check that the watertight seals are properly adjusted.
5 - To release the rear clips, carefully raise the entire glass unit along with the frame, as in Fig. X3.
X1
X2
X3 |
6 - Changing the outer flame burner tip. Fig. L. Take out the main burner tip turning it to the left with a 10 mm spanner. At the same time, hold the burner tip casing in the opposite direction with a 13 mm spanner. Fig. K.
21
