Siemens SS2604 manual Rear Panel

DSL/Cable Router User Guide

LAN Ports	For each LAN port, there are 2 LEDs
(1, 2, 3, 4)	•	Link/Act
		•	On - Corresponding LAN (hub) port is active.
		•	Off - No active connection on the corresponding LAN (hub) port.
		•	Flashing - Data is being transmitted or received via the corre-
			sponding LAN (hub) port.
	•	100
		•	On - Corresponding LAN (hub) port is using 100BaseT.
		•	Off - Corresponding LAN (hub) port connection is using
			10BaseT, or no active connection.
WAN Port	Flashing - data is being transmitted or received via the WAN port.
	Off - no data is being transferred.
Print Act	On - Connection to printer established.
	Off - No connection to printer; printer is Off or Off-line.
	Flashing - Data is being transmitted to the printer.
Print Err	On - Printer error detected.
	Off - No printer error detected.

Rear Panel

			Figure 2: Rear Panel
Printer Port	Standard parallel printer port. If you wish to share a printer, connect
	it here.
Reset Button	This button has three (3) functions:
	•	Reboot. When pressed and released, the DSL/Cable Router
		will reboot (restart).
	•	Diagnostic print-out. If held down for 3 seconds, a diagnostic
		print-out will be sent to the attached printer.
		•	Ensure the printer is ready.
		•	Both Print LEDs will flash simultaneously during the di-
			agnostic printing.
	•	Restore Factory Defaults. This button can also be used to
		clear ALL data and restore ALL settings to the factory default
		values.

To Clear All Data and restore the factory default values:

1.Power Off the router.

4