Hardware and Software Installation
Note: Ensure that the MP
modem and your computer are
powered off while installing
cables.
Note: You must be logged in
with administrative privileges to
install the software.
Install the USB, Ethernet or serial cable
To install the USB, Ethernet, or serial cable, thread the cable
through the vehicle and attach it to the USB, Ethernet, or serial
connector on the MP modem.
Note: Do not connect the cables to the computer until you have
installed the software.
I/O port connections
The MP modem’s I/O port is a standard female DB15HD
connector for remote monitoring of gauges, sensors, and
alarms. If you are planning to use these devices, you need to
create a custom I/O cable. See “Configuring the MP Modem to
Report GPS and I/O Data” on page 41.
Step 5—Install the sof tware Follow these steps to install 3G Watcher and the MP modem
driver:
1. Ensure that the computer has the necessary system
requirements. (See “System requirements” on page 20.)
2. Close any Windows applications that are open on your
computer.
3. Insert the MP modem CD in your CD-ROM drive.
The CD should automatically launch and display a menu.
If not, select Start > Run from the Windows taskbar and
type d:\setup.exe (where d is the drive letter of your
CD-ROM drive).
4. From the CD start-up menu, select installation and
documentation and then MP 3G Watcher installation to launch
the Installation Wizard.
5. Use the Next and Back buttons to navigate through the
wizard.
6. Click Finish in the final window. To close the CD start-up
menu, select the taskbar button to re-display the window,
then select exit in the lower right corner of the window.
7. Power on the MP modem and connect it to your computer.
Windows then completes driver installation.
Rev 1.1 Aug.07 31