Sierra Wireless MP 880W manual Install the MP modem, Mount the MP modem, Mounting the MP modem

Note: Power off the MP modem, your computer, and any other devices while you are connecting cables.

Rev 1.5 Jul.08

Hardware and Software Installation

4.Connect the cable that runs between the MP modem and your computer to the MP modem.

Do not connect the cable to the computer until you have installed the software.

5.Install the software.

6.Start 3G Watcher and activate your account.

7.Test the system.

Install the MP modem

Step 1—Mount the MP modem

If you are using the MP modem in a vehicle, it is usually mounted in the trunk, but other possibilities are under the dashboard or a seat.

Select a location for the MP modem

When selecting a mounting location, remember the following:

•Do not expose the MP modem to weather and environ‐ mental conditions beyond the ranges listed in the environ‐ mental specifications on page 74. Avoid excessive heat from the engine compartment, heaters, or the exhaust system, and extreme cold from direct contact with air conditioners or other cooling systems. Never immerse it in any liquid.

•If you are replacing an MP modem, you can mount the new MP modem in the same location using the existing mounting holes.

•Every device connected to the MP modem, as well as the MP modem itself, should be grounded. (See “Ground the MP modem” on page 28 and “Ground the power harness” on page 34.)

•Route cables to their destinations without using excess wiring.

•Make sure all connectors and the reset button are easy to reach and the indicator lights are visible.

Mounting the MP modem

To mount the MP modem:

1.Use the provided mounting template to mark the location of the mounting holes.

2.Drill 5/32ʺ pilot holes (unless you are reusing holes from a previous MP modem mounting).

27