![](/images/new-backgrounds/1318114/31811443x1.webp)
■When you set the exposure compensation on the camera, both the flash power level and background can be compensated.
■You can use both exposure compensation by flash, and exposure compensation by camera at the same time.
MULTI FLASH MODE
While the shutter is open, the flash will fire repeatedly. By doing so a series of images of the subject will be exposed in one frame. A dark background with a bright subject shows more effectively in this mode. It is possible to set the firing frequency between 1Hz and 199Hz. Up to 100 flashes can be fired continuously. The maximum number of flashes varies, depending on the flash guide number and firing frequency settings. (Please refer to table 3 on the last page)
1.Set the camera’s exposure mode to M mode, and set the F number
2.Press the MODE button until the
3.Press the SEL button until the flash firing frequency starts to blink.
4.Press the + or – button to set the desired flash frequency value.
5.After pressing the SEL button again, the flash power level will blink.
6.Press the + or – button to set the desired power level.
7.Press the SEL button again, the number of flashes will blink.
8.Press the + or – button to set the desired number of flashes.
9.Press the SEL button again, the display will stop blinking.
10.When the ready light of the flash is illuminated, the unit is ready to use.
Note: Please set the shutter speed longer than; Number of Flashes you want Firing Frequency
BOUNCE FLASH
When you take a photo with flash in a room, sometimes a strong shadow will appear behind the subject, if you point the flash head upwards or sideways to reflect the light off the ceiling, wall etc. the subject will be illuminated softly. Press the lock button and adjust the flash head to set the bounce angle.
UP: 0°, 60°, 75°, 90° | DOWN: 0°,7° |
RIGHT: 0°, 60°, 75°, 90 | LEFT: 0°, 60°, 75°,90°, 120°, 150°, 180° |
When the bounce flash mode is activated, a bounce indicator will appear on the LCD panel.
The picture will receive the color from the reflecting surface. Please choose a white surface for bouncing.
Depending on the reflecting surface, the subject distance and other factors, the effective distance range for the TTL AUTO may change. Please check for correct exposure confirmation ( TTL mark on the LCD panel) after releasing the shutter.
Close-up Exposures
For bounce flash can be tilted 7° downward for will blink.
WIRELESS FLASH (Except SD9)
When you use the “Wireless Flash” mode, you can take pictures with a more
22