SIIG 04-0265F Windows XP/Server 2003 32-bit, XP w/SP1 or earlier/Server 2003 continue to step #3

4.InsertthedriverCD,checkCD-ROMdrives,uncheck the other boxes, and click Next. Click Next again to continue.

5.Click Finish, remove the driver CD and restart Windows to complete the installation.

Windows XP/Server 2003 (32-bit)

For New Windows XP/Server 2003 Installation

A new installation of Windows XP/Server 2003 requires a floppy disk for the driver installation. To make this floppy disk, copy the contents of the Floppy folder, found on the driver CD, onto a blank floppy disk then follow the directions below.

1.Install the board and follow Microsoft procedures to install Windows accordingly.

2.Restart your system if prompted by Windows installation.

3.At the Windows Setup screen, press F6 to install the driver.

4.Insert the driver diskette. Press S then press Enter.

5.Select Silicon Image SiI... Controller and press Enter.

6.Press Enter to continue and follow the on-screen instructions to complete the installation.

For Existing Windows XP/Server 2003 Installation

1.Install the board and boot up Windows.

2.At the Found New Hardware Wizard:

XP (w/SP1 or earlier)/Server 2003: continue to step #3

XP (w/SP2 or later)/Server 2003 (w/ SP1 or later): select No, not at this time, then click Next.

3.Insert the driver CD, select Install the software automatically (Recommended), and click Next.

9