Silicon Image SSD-C08G(I)-3150 manual Ata Sel, Rdy/-Bsy, Ireq

ELECTRICAL SPECIFICATION				SSD-CXXX(I)-3150 DATA SHEET
	Table 8: Signal Descriptions (Continued)
	Signal Name	Pin	Type	Description
	-ATA SEL			To enable true IDE mode, this input
	(True IDE mode)			should be grounded by the host.
	-RDY/-BSY	37	O	In memory mode, this signal is:
	(PC Card memory			• Set high when the SiliconDrive CF
	mode)			is ready to accept a new data
				transfer operation.
				• Held low when the card is busy.
				The host memory card socket must
				provide a pull-up resistor.
				At power-up and reset, the RDY/-BSY
				signal is held low (busy) until the
				SiliconDrive CF has completed its
				power-up or reset function. No access
				of any type should be made to the
				SiliconDrive CF during this time. The
				RDY/-BSY signal is held high
				(disabled from being busy) whenever
				the SiliconDrive CF has been
				powered up with +RESET
				continuously disconnected or
				asserted.
	-IREQ			I/O Operation. After the SiliconDrive
	(PC Card I/O			CF has been configured for I/O
	mode)			operation, this signal is used as
	Input Acknowledge			-Interrupt Request. This line is strobed
				low to generate a pulse mode
				interrupt or held low for a level mode
				interrupt.
	-IREQ			In true IDE mode, this signal is the
	(True IDE mode)			active high Interrupt Request to the
				host.

SILICONSYSTEMS PROPRIETARY

This document and the information contained within it is confidential and proprietary to SiliconSystems, Inc.

All unauthorized use and/or reproduction is prohibited.

3150C-10DSR PAGE 11 FEBRUARY 2, 2009