Silvercrest KH 2130 Device components, Putting the device into use, Connecting the transmitter

The device components

Fig. A: The transmitter:

qTransmitter

wLED status indicator e Switch ROOM 1 r Switch ROOM 2

t Infrared connection socket (IR) y Output for a TV

u AV input 2 i AV input 1

o Connection socket

a Transmitter's on/off switch

s Transmitter channel toggle switch (on the underside of the device)

Fig. B: The receiver:

dReceiver

fInfrared receiver

gLED operating indicator

hAudio/Video CINCH outputs

jConnection socket for the supply voltage

kReceiver's on/off switch

lReception channel switch (bottom of device)

1( Wall plug transformer (2 pieces)

2) CINCH—3,5mm jacks cables (2 pieces) 2! SCART—CINCH adapter "IN"

2@ SCART—CINCH adapter "OUT"

2# Infrared cable with 3 transmit diodes 2$ AUDIO adapter 3.5 mm mini-stereo

to CINCH female

2% CINCH—CINCH cable

Putting the device into use

First take all device components from the packaging and remove all packing foil and tape.

Important notice:

Even when the system (transmitter + receiver) is switched off, the manufac- turer still recommends disconnecting the wall plug transformer from the mains power or using a power strip with a shut-off switch. Only in this way is complete switch off assured thus contributing to economical consumer attitude.

Connecting the transmitter

Note:

You can connect two signal sources. The signal to be transmitted can be selected via a switch on the front panel of the transmitter. Thereby the radio transmission set can transmit the image and sound signals of every de- vice that emits a sound and/or video signal via a suitable connection:

•DVD Player / CD Player

•VCR

•Television

•SAT receiver/set top box

•Video camera

•Computer video card, etc.

Connecting signal sources to the transmitter:

•On devices with cinch outputs for the audio and video signals you connect these via one of the supplied CINCH— 3,5mm jack cables 2) to the socket "AV IN 1" i on the rear panel of the transmitter q.

- 6 -