INSTALLING
Continued
14
CONNECTING TO GAS SUPPLY
NOTICE
A qualified service person must connect heater to gas supply. Follow all local codes.
CAUTION
Never connect heater directly to the propane supply. This heater requires an external regulator (not supplied). Install the external regulator between the heater and propane supply.
Installation Items Needed
Before installing heater, make sure you have the items listed below.
• external regulator (supplied by installer, see | • test gauge connection * |
Figure 12) | • sediment trap |
• piping (check local codes) | • tee joint |
• sealant (resistant to LP gas) | • pipe wrench |
•manual shutoff valve *
*An A.G.A.
The installer must supply an external regulator. The external regulator will reduce incoming gas pressure. You must reduce incoming gas pressure to between 11 and 14 inches of water. If you do not reduce incoming gas pressure, heater regulator damage could occur. Install external regulator with the vent pointing down as shown in Figure 12. Pointing the vent down protects it from freezing rain or sleet.
Propane
Supply Tank
External
Regulator
Vent Pointing
Down
Figure 12 - External Regulator With Vent Pointing Down
WARNING
Never connect heater to private
CAUTION
Use only new, black iron or steel pipe.
103448