Vanguard Heating VS30PR Installing, Continued, Gas Control, 103448, Installation Items Needed

INSTALLING

Continued

Installation Items Needed

•hardware package (provided with heater)

•approved flexible gas hose (not provided) (if allowed by local codes)

•sealant (resistant to propane (LP) gas, not provided)

•electric drill with 3/16" drill bit

Note: Install optional GHRCT Receiver and Hand Held Remote Control Kit (see Accessories, page 30) before installing gas log heater. See installation instructions included with the kit.

1.Apply pipe joint sealant lightly to male threads of gas fitting. Connect approved flexible gas hose to inlet side of gas control (see Figure 10).

2.Position heater base assembly in fireplace.

3.Mark screw locations through holes in front panel of base (see Figure 11). If installing in a brick- bottom fireplace, mark screw locations in mortar joint of bricks.

4.Remove heater base from fireplace.

5.Drill holes at marked locations using 3/16" masonary drill bit.

6.Attach base to fireplace floor using masonry screws (in hardware package).

7.Connect to gas supply. See Connecting To Gas Supply, page 14.

Gas Control

Flexible Gas Hose (if allowed by local codes)

Figure 10 - Attaching Flexible Gas Hose to Heater Gas Regulator

Masonry Screw Masonry Screw

Figure 11 - Attaching Base to Fireplace Floor

Continued

103448

13